Home  |  About PX  |  Employee Info  |  Employment Opportunities  |  Procurement  |  Health & Safety  |  Visitor Center  

 

Visitor / Contractor Access and Training Information

PUBLIC TOUR POLICY: Security requirements preclude public tours of Pantex

NOTICE: All visitors and contractors must enter the Plant via the East Gate. You will be turned away if you approach the West Gate.

This page contains information about Pantex Plant training requirements for Official Visitors and Contractors ONLY. All requirements must be completed to obtain and retain Site access.

The Visitor Training Matrix identifies the training requirements for general plant visits, meetings, etc. The Contractor Training Matrix identifies the training required for persons performing work/services at Pantex.

Visitors should be aware that the Pantex Plant is an industrial site and that everyone is expected to comply with the B&W Pantex Footwear Policy. The policy applies to all areas of the plant; therefore, please review the Policy and arrive wearing compliant footwear.

If a radiation dosimeter will be needed during your visit to Pantex Plant, you must provide your current year-to-date dose information (use Pantex Form PX-2868) before the dosimeter can be issued. The need for a dosimeter may be determined by contacting your Pantex Point of Contact (POC) or Subcontract Technical Representative (STR) in advance.

Pantex Point of Contact (POC) or Subcontract Technical Representative (STR) shall ensure the necessary training has been completed before access to Pantex is approved.

POCs and STRs: Contact the Visitor/Contractor Division Training Officer at
477-7890 or 477-3603 to ensure necessary training paperwork is in place to expedite Visitor/Contractor entry.

Required Reading

Visitor/Contractor Orientation (Course # 553.05), is required for all visitors and contractors to the Pantex Plant. For your convenience, this information can be read prior to your visit. NOTE: Additional training may be required depending on job requirements and/or facility requirements.

    1. Open and read the Orientation (Course #553.05)

    2. Once you have read these materials, print, complete and sign the Training Completion Report for requirement ST 553.05; found as the last page of the Orientation. Bring the completed document with you when you arrive at the Plant.

Cyber Security Briefing (Required if access to any Pantex computing resources is needed)

Bring the completed PX-form(s) to Access Control (your check in point) on your first day at the plant or they can be mailed to:

Training Records
B&W Pantex
12-15A
P. O. Box 30020
Amarillo, Texas 79120-0020

Faxed copies of Training Completion Reports are not acceptable.

If you have any questions or concerns, ask your Pantex Point of Contact (POC).


General Employee Training (GET) Test-Out Study Guides

If you have been directed to this web site for GET test-out materials, please be aware of our testing policy:

    • You may NOT use your notes/study guide while taking the test

    • Passing score for each test is 80%; score(s) below 80% will require attending the classroom training.

Once you have studied the materials and are prepared to test-out, contact your Pantex POC who will coordinate the test-out through the Visitor/Contractor Division Training Officer.

Study Guides:


Notice to Users | Map to Pantex | Energy.gov